Tuesday, 19 May 2020 19:04

Electromechanical Engineering Department at UOT holds an electronic workshop about (the manufacture of drones - stages and applications)

Rate this item
(0 votes)

Electromechanical Engineering Department at UOT in cooperation with Continuing Education Center held an electronic workshop (the Free Conference Call platform) delivered by Assist. prof. Dr. Saadi Kurdish, titled “The manufacture of drones - stages and applications”.

 The workshop dealt with the great expansion witnessed by aviation world in the drones field manufacture, due to its simplicity in design and low cost, as the drones manufacture depends in terms of tasks on the type of systems and payloads installed on them, and these loads vary from one plane to another, in general the drones are manufactured with basic systems, perhaps found in all types of drones, such as flight control system (autopilot), air navigation systems and communication system with ground stations.

Modern technology has contributed to reducing the weights of these systems and thus has resulted in the manufacture of small drones that are low-cost, more efficient, and diverse in the payloads installed on them, and also one of the things that led to the success of these drones is the technology of their manufacture.

 

Read 3952 times
1655061
  Today Today37
YesterdayYesterday0
  This_Week This_Week37
  This_Month This_Month37
  All_Days All_Days1655061
Highest Visitors 10-09-2024 : 27
                                Web Designers
Top